As we all know, although China is a big producer of fasteners, but because of technical backwardness, the equipment for producing fasteners is mostly imported from abroad. However, with the upgrading of R & D level in China, the domestic fastener equipment has risen to a certain height. It is estimated that in 2020, the production equipment and testing equipment in China's fastener enterprises will be fully implemented, and the localization will reach over 80%.

In view of the current situation, there is a gap between the standard parts market of the whole hardware industry in 2013 and our imagination. Under such a form, we can see that the screw economy in the international market, including the domestic market economy, is not enough power. The impact capacity is also a serious shortage, that is to say, this is the most inResilient time since the economic recovery.

From the second quarter analysis report of standard parts, we can see that the total export volume of our country has been reduced to a level and has not yet achieved the expected breakthrough, which is very destructive. We can see that the total output value of the standard parts that we can achieve in the quarter is about 73 billion 200 million yuan, up 0.5% from the same period last year, but this increase is relatively small compared with that of last year. And we can see a lot of falling data on the export volume. According to customs statistics, total exports in standard parts industry screw products foreign trade was $5 billion 460 million, a negative growth of huge, reduced compared to -9.1%. in the screw products importer is $3 billion 250 million, this data is also negative growth, and also reached two figures. Export is also very unsatisfactory. Although production has increased, the export of screw products has increased by -4%. compared with the same period. It can be said that in the quarter, the whole standard industry has a comprehensive downward trend.